About Robelle
Back to the download page

Suprtool Open Trial Release
Installation Instructions

You may want to print this page, for reference.

FTP upload of binary file

Once you have downloaded the binary file to your PC, you need to upload it to the your Linux server.. Using your favorite FTP utility, connect as root, and use a binary transfer to PUT the file to the HP-UX server.

Microsoft Windows XP [Version 5.1.2600]
(C) Copyright 1985-2001 Microsoft Corp.
C:\Download>ftp dev.robelle.com
Connected to dev.robelle.com.
220 HP ARPA FTP Server 
User (dev.robelle.com:(none)): root
31 Password required for root.
Password:
230 User root logged on
ftp> binary
200 Type set to I.
ftp> cd /tmp
ftp> put lintar.gz
ftp> quit
221 Server is closing command connection

Preparing for Install

Backup the Account (Optional)

You can save your current files in the /opt/robelle account using the following steps.

Logon as root.
su -
tar cvf robbackup /opt/robelle/*

Installing the Software

Once you have the file on your Linux Box, you need to install it:

  1. Restore the software.
  2. Apply the license codes.

Restore the files

Logon as root and cd to /tmp.

su -
cd /tmp

Gunzip the download:

gunzip lintar.gz

Please note that some versions of Chrome gunzip the file while you are downloading the file. A guide may be that if the file is less than 3Mb it has NOT be gunzipped, but over 7Mb then the file has been gunzipped and the gunzip step does not need to be done.

Create the directory where the Suprtool files will reside. Obviously if the directory already exists then there is no need to make the directory.

mkdir /opt/robelle

Unpack the Robelle files and Apply the License:

While logged on as root:
cd /opt/robelle
tar xvf /tmp/lintar
cd bin
./extend
Please note that when you run extend you MUST be in the /opt/robelle/bin directory. Enter the two codes that will allow Suprtool to run for a particular time period.

You can now run Suprtool and you should test that Suprtool runs by doing:

/opt/robelle/bin/suprtool
EA (Exit Abort) gets you out of Suprtool.

Problems

Suprtool/Open on Red Hat (and other Linux platforms), relies on the 32-bit libc environment. If you don't have this installed you will likely see the error below: # ./suprtool -bash: ./suprtool: /lib/ld-linux.so.2: bad ELF interpreter: No such file or directory
Solution: yum install ld-linux.so.2 So far this is the solution that we've found to work best.

Cleanup

If Suprtool runs and you like to keep things clean like we do, we recommend that you remove the tar file with:
	rm /tmp/lintar

Feedback

As this product is currently a Beta release please send any feedback to neil@robelle.com.